Industrial Control PCB Material & Stack-Up Selector | PCBark

Industrial Control PCB Material & Stack-Up Selector

Tick the conditions your board must survive. We map them to the laminate, copper and protection an industrial control PCB needs — the same logic our engineers apply during DFM.

1. Thermal & power conditions

Runs hot or uses lead-free reflow (cabinet > 60°C) Carries high current (motor drive, power stage) Needs to move heat off LED / power devices

2. Signal & environment

High-speed bus / controlled impedance Corrosive, humid or dusty plant environment High-voltage section (≥ 500 V)

3. Reliability target

Failure has safety / zero-downtime consequence

Recommended industrial stack-up

Get a free DFM review on your Gerber/BOM →

Guidance only — based on IPC-4101 materials, IPC-6012 reliability classes and IPC-2221 clearance rules. PCBark confirms the final stack-up against your design files.

Industrial Control PCB Material & Stack-Up Selector

1. Thermal & power conditions

2. Signal & environment

3. Reliability target

Recommended industrial stack-up

Trending now